Table of Contents
Advertisement
FCC Information
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment
and receiver.
•
Connect the equipment into an outlet on a
circuit diff erent from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio / TV
technician for help.
WARNING: Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
Ventilation
You must adequately ventilate the product. Make
sure there is adequate space around the unit to
provide proper air fl ow for ventilation. See diagram.
This product complies with DHHS Rules 21 CFR Sub-
10 cm
10 cm
chapter J. Applicable at the date of manufacture.
For your Safety
The AC power plug is polarized
(one blade is wider than the other)
and only fi ts into AC power outlets
one way. If the plug won't go into
the outlet completely, turn the
plug over and try to insert it the
other way.
If it still won't fi t, contact a qualifi ed electrician to
change the outlet, or use a diff erent one. Do not at-
tempt to bypass this safety feature.
Removing the power plug is the only way to com-
pletely remove power from your product. Make
sure the power plug remains easily accessible.
Note:
This unit has been designed to play back BD-video
with region "A" and DVD-video with region "1". You
cannot play back BD-video or DVD-video that are
labeled for other regions. Look for the symbols on
the right on your BD-video or DVD-video. If these
region symbols do not appear on your BD-video or
DVD-video, you cannot play back the disc in this unit.
The letter or number inside the globe refers to region
of the world. A BD-video or DVD-video labeled for a
specifi c region can only be played back in the unit
with the same region code.
EN-4
7 cm
10 cm
7 cm
Advertisement
Table of Contents
