2NGA000821 A
Section 5
5.1
5.2
REX610
Installation Manual
Connecting
Required tools
When handling CT/VT terminals in slots C1 and D2 respectively, use a flat-blade
screwdriver.
Table 3:
Required tools
Terminal
Slotted screw (part of
the connector)
CT (C1)
M3
VT (D2)
M2.5
Connecting wires
All connections are made on the rear of the case. No soldering is needed.
•
Open the screw-compression type terminals before inserting any wires. By
default the terminals are closed at the time of delivery.
•
Use fine wire in door mounting.
Screwdriver blade
Width
Thickness
∅3.5 mm (0.1377 in)
Max. ∅0.6 mm
(0.02362 in)
∅3.0 mm (0.1181 in)
Max. ∅0.5 mm
(0.01968 in)
Section 5
Connecting
33