Table of Contents
Advertisement
Friends
z Friends List
Displays all Friend targets that you have
entered.
L "No ID" is displayed when there is no
Friend target.
L See page 49 for setting a Friend.
z Friends Alarm
• Function
You can select whether or not to turn
the following alarm function ON or OFF
when a vessel that is entered into the
Friends List is detected.
ON:
The alarm function is ON. An
alarm sounds, and a popup
screen is displayed when a
vessel that is entered into
the Friends list is detected,
regardless of the set range.
ON
(in range): The alarm function is ON
when a vessel that is entered
into the Friends list is
detected in the set range.
OFF:
The alarm function is OFF.
• Audible Alarm
You can select whether or not to sound
the Friends alarm.
ON: The alarm sounds.
OFF: The alarm does not sound.
• Range
Set the range to between 0.1 and 6.0
NM (in 0.1 NM steps) for the alarm
function.
AIS Power Save
You can select whether or not to turn the
AIS Power Save function ON or OFF.
ON: The transceiver receives only AIS
information and DSC calls while
in the plotter screen, the AIS List
screen, or the details screen.
OFF: Turns OFF the function.
AIS RECEIVER
MOB Support
z Function
You can select whether or not to turn
the MOB Support function ON or OFF.
L This function is activated only when:
• Your current position data is valid.
• The AIS target is within the set range.
ON: When water is detected, the
closest AIS target is automatically
selected on the Target list screen
to immediately transmit an
Individual DSC call.
OFF: Turns OFF the function.
z Range
Set the area range to between 0.1
and 6.0 NM (in 0.1 NM steps) for the
function.
Power Support
z Function
You can select whether or not to turn
the Power Support function ON or OFF.
L The output power level may be set
to only low power, depending on the
channel or setting.
ON: When an Individual DSC call is
transmitted to the selected AIS
target, the output power level
may automatically change during
transmission, depending on the
distance between the target
and your position. Low power
is set while the target is in the
set range, and high power is set
when the target is out of the set
range.
L You can also change the output
power level by pushing
OFF: Turns OFF the function.
z Range
Set the area range to between 0.1
and 6.0 NM (in 0.1 NM steps) for the
function.
10
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
.
54
Advertisement
Table of Contents
