Installation - Logic Controls CR3000 User Manual

Model CR3001 - Parallel Interface:
Connect the drawer to the computer as shown in Figure 3. Connect
the power adapter output to the power input jack.
Whenever the POS application software transmits the pre-set
security code to the computer's parallel (LPT1) port, the drawer will
open. The security code was pre-set by the manufacturer at (07
Hex) and can be re-configured as shown in Figure 4. Under normal
operations, the selected pre-set code should be a non-displayable
ASCII character.
NOTE: Other parallel devices, such as a printer, can be con-
nected to the same parallel port.

INSTALLATION

Your cash drawer has been pre-assembled to make the installation
as simple as possible.
Model CR3000
1. Remove the cash drawer from its shipping container.
2. Remove the keys and interface cable from its plastic bag.
3. Connect the interface cable to the printer.
4. Connect the other end of the interface cable to the "Control
Signal Input" of the cash drawer.
Model CR3001 with serial interface
1. Remove the cash drawer from its shipping container.
2. Remove the keys and interface cable from its plastic bag.
3. Connect the DB9F connector of the interface cable to the COM1
or COM2 port of the computer.
4. Connect the DB25F connector of the interface cable to the DB25M
"Serial Input From Computer" connector on the cash drawer.
NOTE: The interface cable may not be used for other
applications.
5. Connect the power adapter output to the "Power Input From
Adapter" connector on the cash drawer.
3