Setup/Programming Instructions; Operation - Listen LR-600 User Manual

Wireless fm receiver/speaker 72 or 216 mhz
Hide thumbs Also See for LR-600:
Table of Contents

Advertisement

LR-600 Operation
Power the unit ON
Turn the unit on by sliding the power switch on the rear of the unit to the
On position. The LCD will activate; if using the LR-600 on the power
supply, the LCD backlight will activate and remain on. If you are using
the unit on batteries, the LCD backlight will operate for 12 seconds after
any button is pressed, and then dim to conserve battery life.
LCD Display
Once the unit is on, the LCD display will illuminate. Notice that when the unit is
in operation on the power supply, the LCD backlight will remain lit continuously.
When on battery power, the backlight will remain lit for 10 seconds after any
button is pushed. This is designed to save battery life.
Volume Control
Adjust the volume setting for a comfortable level by pressing the VOLUME UP and
DOWN buttons on the top of the unit. The volume setting (a number between 0
and 26) will be shown on the display. To lock the volume setting see page 14.
Channel Selection
To select a program channel, press the Channel Select button on the top of
the unit. To program this function see page 13. If channels have not been
programmed, the unit will step through all available channels as you repeatedly
press the CHANNEL SELECT button. If channels have been programmed, you may
wish to use the Seek button on the rear panel instead. Pressing Seek will cause the
LR-600 to search for an available transmission. You may also use the Channel UP
and DOWN buttons on the rear panel to step through the channels available to
the LR-600.
Battery Icon
The battery icon shows the amount of battery life remaining in full, ½, ¼ and
flashing increments (indicating low battery). When charging, the battery icon
changes through all of these states to show it is charging. See page 11 for
complete battery information.
LR-600 manual_2006_04_12.indd Sec1:7
LR-600 manual_2006_04_12.indd Sec1:7
Signal Strength
Padlock Icon
Control panel (rear of unit)
Channel or Volume
Battery
Control panel
(top of unit)
7
4/16/2007 11:0
4/16/2007 11:0

Advertisement

Table of Contents
loading

Table of Contents