Table of Contents
Advertisement
LR-600 Battery Charging
Battery Charging
For NiMH battery operation, you must charge the batteries for 13 hours before use. To
charge the batteries, plug the unit into the power supply or external +12VDC supply and
move the power switch to either CHG or ON. The batteries will charge in either position.
When the batteries are charging, the battery icon changes from ¼ to ½
to full and then repeats to indicate charging.
When not using the unit, it is advisable to leave the unit connected to
the power supply to keep the batteries fully charged. This will not
damage the batteries.
When the batteries are fully charged, the unit will automatically shut off.
To reactivate the unit, turn the unit OFF and then back ON.
NOTE: During battery operation, if the battery icon begins flashing
on the Low level (one bar showing), your batteries are almost
exhausted and shutdown is imminent. Connect to a power supply
or replace the batteries.
LR-600 manual_2006_04_12.indd Sec1:11
LR-600 manual_2006_04_12.indd Sec1:11
In Charge mode, the battery symbol
will cycle between low, mid and full.
4/16/2007 11:0
4/16/2007 11:0
11
Advertisement
Table of Contents
