AEG CDE84751FB User Manual page 23

Problem
The control bar for hood
blinks and the hood does
not start or turns off.
The hood fan does not
work properly when the
hood functions are activa‐
ted.
The steam produced dur‐
ing cooking is not suffi‐
ciently absorbed by the
hood.
and a number come
on.
Possible cause
The cookware is unsuitable.
The diameter of the bottom
of the cookware is too small
for the zone.
The fan may turn off by itself
in certain conditions, e.g.
when the room is not proper‐
ly ventilated.
The ambient temperature
surrounding the hood is too
high.
There is insufficient air circu‐
lation inside and around the
hood.
The lids on the cookware are
not properly placed.
The hood filter is oversatura‐
ted.
There is an error in the hob.
ENGLISH
Remedy
Use cookware suitable for in‐
duction hobs. Refer to "Hints
and tips".
Use cookware with correct di‐
mensions. Refer to "Technical
data".
Open the window (you may
need to install the window
switch, refer to "Hints and Tips
for the Hood"). Press any sym‐
bol. The hood operates again.
Deactivate the hob and unplug
it from the main power supply.
Wait at least 10 seconds, then
plug it in again.
Other suggestions:
Try to cool down the tempera‐
ture of the surrounding area.
Take out the hood filter and re‐
move the residual moisture
from the inside of the hood.
Refer to "Care and cleaning".
Leave the hood system to dry
for one day, then activate the
hood again.
If your cookware does not
have vented lids, make sure to
tilt the lids so that the released
steam is directed towards the
hood.
Refer to "Hints and Tips" for
information on the special
Steam Vented Lids recom‐
mended to be used with the in‐
tegrated hood.
Clean the hood filter and reset
the notification. Refer to "Care
and cleaning".
Deactivate the hob and acti‐
vate it again after 30 seconds.
If comes on again, discon‐
nect the hob from the electrical
supply. After 30 seconds, con‐
nect the hob again. If the prob‐
lem continues, speak to an Au‐
thorised Service Centre.
23