Table of Contents
Advertisement
Additional run time in minutes
Additional water consumption in
litres
Additional power consumption in
kWh
The consumption values specified
are laboratory measurements determ-
ined in accordance with the currently
applicable standard and using the
Eco 50° programme and the factory
value of the water hardness is set to
9 - 20°E.
Rinse aid system
Rinse aid system
Rinse aid system
Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the rinse aid refill indicator lights
up, top up with rinse aid. Only use
rinse aid for domestic dishwashers.
Press the catch on the lid of the
1.
dispenser for rinse aid
.
7
5
0.05
and lift
2
1
Add rinse aid up to the max mark.
2.
If rinse aid spills out, remove it
3.
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
Close the lid of the dispenser for
4.
rinse aid.
a The lid clicks into position.
Setting the amount of rinse
aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
Press
.
1.
To open the appliance settings,
2.
press
is flashing on the display.
a
Press
3.
flashes.
Press
repeatedly until the
4.
right amount of rinse aid has been
set.
0, 1, 2 or 3 LEDs will light up ac-
cordingly.
The factory setting is level 2 ("LED
A and LED B" → Page 15).
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
Rinse aid system en
max
for 3 seconds.
repeatedly until
25
Advertisement
Table of Contents
