NCTeco NG-RV1100 User Manual page 11

2. Place the charging stand against a
wall on a flat floor, and then connect
power.
Note:
- Make sure there is a space of more than
0.5 meters on both sides and more than
1.5 meters in front.
- When installing, try to keep the power cord
in the air; if it is close to the ground, it may
be dragged by the host, causing the charging
stand to lose power.
- The charging indicator light is always ON
when the power is on.
3. Install brush
Match the left brush (L) and
the right brush (R) to the
letters L and R on the bottom
case, and press the bottom
vertically.
Note:
- With insufficient power cannot being turned on, please place the host on the charging
stand the device will automatically turn on, because the device can work normally only
when the power is ≥ 20%.
- (As the picture shows) The front end of the machine is facing the charging stand, so that
the charging contacts on the main unit are in contact with the charging shrapnel and the
distance between the front end of the machine and the charging stand is about 0 to 2cm.
Installation Steps
1. Connect the power cord, and
then put the excess wire into
the wire box.
1.6ft/0.5m
5ft/1.5m
Turn on the main power switch, until
the indicator light is always on, and
then put the host on the charging
stand to charge.
9
1.6ft/0.5m