Installation Steps - NCTeco NG-RV1100 User Manual

When using the robot for the first time, keep an eye on the robot to see if any problems occur.
1
4
1. Remove the power cords and small objects from the floor that may entangle robot.
2. Robot may climb on top of objects less than 0.59in. /15mm in height. Remove these
objects if possible.
3. Keep the robot away from wet areas.
4. Keep the robot away from spaces lower than 2.95in. /75mm to prevent the robot from
getting stuck. If necessary, place a physical barrier to block off the problem areas.
5. Fold tasseled edges of area carpets underneath to prevent tangling robot. Avoid cleaning
very dark-colored high-pile carpets or if carpet is thicker than 0.86in. /22mm as they may
cause robot malfunction.
6. Anti-drop sensors prevent robot from tumbling down stairs and steep drops. They may
work less effectively if dirty or used on reflective/very dark-colored floors. It is
recommended to place physical barriers to block off areas where robot may fall.
Place physical barriers in front of fireplaces and areas that may cause

Installation Steps

damage to the robot if entered.
2
5
8
3
6