Pre-Operation Checks - McConnel ROBOMOZ Operator's Manual

PRE-OPERATION CHECKS

WARNING! All checks or inspections of the machine should be performed with
the machine parked on firm level ground with the engine switched off and the
starting key removed.
The following checks should be made daily before using the machine;
 Check all safety guarding is in good condition and fitted correctly.
 Check nuts and bolts for tightness, retighten if required.
 Check flail head for damaged or missing flails – replace if required before use.
 Check oil, coolant and fuel levels, replenish if required.
 Check filters – clean or replace if required.
 Check radiator matrix is clean – clear blockages if required using compressed air.
 Lubricate machine as per details stated in the maintenance section.
Work and Work Area Precautions
 Always inspect the work area prior to operations; check for and remove foreign bodies
such as large stones, metal component, wire and glass etc. which could damage
machine component or be ejected by the flail head. Any immoveable object should be
visually marked or avoided.
 Ensure the area is clear of animals and persons. Never manoeuvre the machine into an
area where you can no longer see it working.
 Only work the machine in grass or brushwood that is within its cutting capability;
attempting to cut materials beyond the machines capability will damage components.
 When working on slopes always start at the bottom and work up.
 Never run the machine down a slope in excess of 50°
 Never operate the machine on slopes or ground where there is a risk of overturn.
25