Password; Status - Linksys USBVPN1 User Manual

Instant etherfastseries usb vpn & firewall adapter

Hide thumbs Also See for USBVPN1:

Table of Contents

Enlarged version

Password

The Password screen, shown in Figure 7-24, allows you to change the password

and restore default settings on the Adapter.

Adapter Password It is strongly recommended that you set a password for the

Adapter. The default password is admin. If you don't change the password, all

users on your network will be able to access the Adapter using the default pass-

word admin.

Restore Factory Defaults If you select the Restore Factory Defaults option

and click the Apply button, you will clear all of the Adapter's settings.

Do not restore the factory defaults unless you are having difficulties with the

Adapter and have exhausted all other troubleshooting measures. Once the

Adapter is reset, you will have to re-enter all of your configuration data.

To apply any of the settings you change on a page, click the Apply button, and

then click the Continue button. To cancel any values you've entered on any

page, click the Cancel button.

Instant Broadband

Figure 7-24

Series

USB VPN & Firewall Adapter

The Status screen, shown in Figure 7-25, displays the Adapter's current status

and reflects the data and selections you've entered using the Setup screen.

All of the information provided on this screen is read-only. To make changes,

select the Setup tab.

Host Name This field shows the name of the Adapter. This entry is necessary

for some ISPs.

Figure 7-25

Note: The information provided and buttons available may

vary depending on the Adapter's settings.

Table of Contents