Overview; Installing Nt Networking And The Adapter's Driver - Linksys LNE100M User Manual

Chapter 7: Manual Installation and
Setup for Windows NT

Overview

The following instructions will set up the Adapter in a computer running NT
4.0 Server/Workstation. You should have your original Windows NT CD-ROM
available during the installation,
as you might be asked to supply
it. Always consult your NT docu-
mentation if you have questions.
To manually install the network driver for an NT 4.0 Server or Workstation:
1. Log in to Windows NT as an administrator.
2. Click the Start button, select Settings, open the Control Panel, and dou-
ble-click on the Network icon.
3. If you have not pre-
viously installed
Windows NT net-
working on your
computer, the mes-
sage shown in
Figure 7-1 will
appear.
• If you see this message, click the Yes button to install NT networking along
with the Adapter's driver, and continue with step one on the following
page.
• If you don't see this message, NT networking is already installed. Skip to
the Installing the Adapter's Driver if Networking is Already Installed
section.
27
Instant EtherFast Series
®
Figure 7-1
EtherFast ® 10/100 Managed Network Adapter

Installing NT Networking and the Adapter's Driver

1. After clicking on the Yes button, the Network Setup Wizard window will
appear.
2. When the screen shown in Figure 7-2 appears, put a checkmark next to
Wired to the network and then click the Next button.
3. Click the Select from list... button to select the network adapter. (See
Figure 7-3)
Figure 7-2
Figure 7-3
28