Table of Contents
Advertisement
2.
Use the attached mounting screws (M4 length 10 mm) to secure the mounting bracket on the
installation surface.
Screw: M4, 10 mm length, bind-head
Clamping torque: 1.47 N · m (15 kgf · cm)
3.
Attach the drop-prevention wire.
Screw in the drop-prevention wire onto the ceiling mount bracket with the supplied main unit
mounting screw (M4 x 6).
Clip in the other end of the drop-prevention wire unto the protruding hole near the middle of the
camera bottom panel.
Note
Do not do this work while holding the camera head since doing so may result in malfunctioning of
the unit.
The drop-prevention wire is designed to be used for installation where the unit is suspended from
an overhead surface so do not subject it to the weight of units other than the unit.
Screw in the drop-prevention wire with
the supplied main unit mounting screw.
Clip in the other end of the drop-prevention
wire unto the protruding hole near the middle
of the camera bottom panel.
15
Advertisement
Table of Contents
