Table of Contents
Advertisement
Do not install or use the unit in
the following kinds of locations.
On walls (where the unit would be
installed sideways)
In locations (including places such as
under the eaves of a building) where
the unit would be directly exposed to
rain or water
In locations such as kitchens where
there are high concentrations of
steam and grease
In outdoor locations or hot places
where the temperature will exceed
°
°
40
C (104
F)
In cold locations where the
temperature will drop below 0
°F)
In locations where the humidity will
exceed 85%RH
In locations where chemicals are
used such as near swimming pools
At sea, in coastal areas or in locations
where corrosive gases are emitted
In locations where radiation, X-rays,
or strong radio waves or magnetic
fields are generated
In locations where the unit would be
subject to a great deal of vibration
such as on board a vehicle or ship
(this unit is not designed to be used in
vehicles)
In locations where the temperature is
subject to sudden changes such as
near the air outlet of an air conditioner
or near a door which allows the
outside air to come in.
Be absolutely sure to use the
supplied brackets and screws to
install the camera.
Do not mount the unit by employing
any methods other than those
specified.
Do not remodel the mounting bracket
or mounting screws provided with the
unit.
What to avoid to ensure that the
unit will perform stably over a
prolonged period
Using the unit for a prolonged period in
°
C (32
Ensure that a cooling unit or heating
Before installation, always
disconnect the DC connector
When installing, always use the supplied
components. Do not disassemble or modify
the wall mount adaptor.
Tightening up the mounting
screws
Tighten up the screws and bolts
After tightening up the screws and
Use the specified tools and tighten the
Tighten up the screws using the
10
a location with high temperature and
humidity levels will cause its parts to
deteriorate and shorten its service life.
unit will not blow any air directly toward
the installation location.
securely to the degree that is
appropriate for each of the materials
used in the mounting location and
structures.
bolts, check that there is no
unsteadiness and that the parts have
been tightened securely.
screws firmly.
specified torque driver. Do not use
electrical drivers or impact drivers.
Advertisement
Table of Contents
