Amana AGR4230BAW Installation Instructions Manual page 15

2. Remove the cap from the gas pressure regulator using
a flat-blade screwdriver.
NOTE: Make sure sealing washer remains in the same
position.
3. To convert to Natural gas, unscrew the plastic adjustment
screw by hand, turn it over, and screw it in again.
Inlet pressure
to LP gas
180º
A. Cap
B. Sealing washer
C. Adjustment screw
4. Reinstall the cap.
To Convert Surface Burners
1. Remove burner grate, burner caps and burners.
A
B
A. Burner cap
B. Burner
A
A. Cap
Inlet pressure
to Natural gas
A
B
C
2. Locate Natural gas orifice spuds for top burners in the bag
containing literature included with the range. Three Natural
gas spuds are stamped "149," and one is stamped "110
(Red/Brass)."
3. Remove the LP gas orifice spuds using a 7 mm combination
wrench.
4. Install the Natural gas orifice spuds using a 7 mm
combination wrench.
A. Spud
B. Holder
NOTE: The range is equipped with 3 standard burners and 1
simmer burner (right rear).
A. Standard burner - Natural gas orifice spud number 149
B. Standard burner - Natural gas orifice spud number 149
C. Simmer burner - Natural gas orifice spud number 110 (Red/Brass)
D. Standard burner - Natural gas orifice spud number 149
5. Place LP gas orifice spuds in the parts bag for future use
and keep with the bag containing literature.
6. Reinstall burners, burner caps, and burner grates.
A
B
15