Corsair iCUE 220T RGB Mid-Tower Gaming Case Manual

CASE SPECIFICATIONS

Length: 398mm
Width: 210mm
Height: 450mm
Maximum GPU length: 300mm
Maximum CPU height: 160mm
Maximum PSU length: 180mm

Fan locations:
Front: 3x 120mm / 2x 140mm
Top: 2x 120mm / 2x 140mm
Rear: 1x 120mm

Radiator compatibility:
Front: 360mm / 280mm
Top: 240mm
Rear: 120mm

ACCESSORY KIT CONTENTS

Fan screws (short)

MBD / HDD screws

ODD / SSD screws

Motherboard standoffs

Washer

Cable ties

Lighting Node CORE standoff

Lighting Node CORE screw

CASE FEATURES

A — TEMPERED GLASS SIDE PANEL
B — DUST FILTERS
C — SSD TRAYS
D — HDD TRAYS
E — SOLID SIDE PANEL
F — FRONT BEZEL
G — 3x 120mm RGB FANS
H — LIGHTING NODE CORE

REMOVING THE SIDE PANELS

INSTALLING THE MOTHERBOARD

INSTALLING HDDs

INSTALLING SSDs

INSTALLING PSU

INSTALLING PCI-e CARDS

REMOVING THE FRONT BEZEL

MOVING HDD CAGE

INSTALLING THE FRONT I/O CONNECTORS

CHANGING LOCATION OF THE LIGHTING NODE CORE

INSTALLING THE LIGHTING NODE CORE

1. Turn your system off prior to installing your Lighting Node CORE.
2. Plug the 9-pin USB into an available internal USB 2.0 header in your system.
3. Plug the SATA connector into an available SATA connector on your PSU.
4. The Fan LED wiring must be connected to the fan hub in the order you want the lighting effects to be displayed.
5. Fans must start at "1" and continue in series. 1 > 2 > 3 > 4 > 5 > 6
6. Any fan not connected in series will break communication and the RGB LED lighting function will not work.

FREQUENTLY ASKED QUESTIONS

1. Does the polarity matter with the I/O panel's power and reset header? No, only the LED headers.
2. Who should I contact if I received my case damaged or one of the fans is no longer working? Please go to support.corsair.com and request an RMA so that we can replace the damaged part(s).
3. Where can I mount a fan?

To learn more about this case visit the product page at corsair.com.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

This device must not be co-located or operating in conjunction with any other antenna or transmitter. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. CAN ICES-3(B)/NMB-3(B).

CORSAIR MEMORY, Inc. declares that this equipment is in compliance with Directive 2011/65/EU. A copy of the original declaration of conformity can be obtained at "corsair.com/documentation".
Operating Temperature: 0°C ~ + 40°C
The Authorized Representative in Europe
Corsair Memory, BV
Wormerweg 8, 1311 XB, Almere, Netherlands

NOTE ON ENVIRONMENTAL PROTECTION

After the implementation of the European Directive 2012/19/EU in the national legal system, the following applies:

• Electrical and electronic devices may not be disposed of with domestic waste.
• Consumers are obligated by law to return electrical and electronic devices at the end of their service lives to the public collecting points set up for this purpose of point of sale. Details to this are defined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that a product is subject to these regulations. By recycling, reusing the materials or other forms of utilizing old devices, you are making an important contribution to protecting our environment.

R-R-CSI-RWF0040
Applicant Name: CORSAIR MEMORY, Inc.
Product Name: Lighting Node CORE
Model No.: RWF0040
Manufactured Year & Month: Please refer to S/N
Manufacturer & Country of Origin: CORSAIR MEMORY, Inc./Made in China

WEB: corsair.com
PHONE: (888) 222-4346
WARRANTY: corsair.com/support/warranty
SUPPORT: support.corsair.com
BLOG: corsair.com/blog
FORUM: forum.corsair.com
YOUTUBE: youtube.com/corsairhowto

© 2019 CORSAIR MEMORY, Inc. All rights reserved. CORSAIR and the sails logo are registered trademarks in the United States and/or other countries. All other trademarks are the property of their respective owners. Product may vary slightly from those pictured. 49-001998 AA

Videos

Corsair iCUE 220T RGB Airflow Review Video

Documents / Resources

References

• PC Components | Gaming Gear | CORSAIR
• http://corsair.com/documentation
• http://corsair.com/support/warranty
• http://corsair.com/blog
• Home - Corsair Community
• CORSAIR LAB - YouTube

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Corsair iCUE 220T RGB Mid-Tower Gaming Case Manual