Temperature Guide; Before Use; Location; Using The Steam Generator - Morphy Richards Speed Steam Pro Instructions Manual

RN332103MEE Rev2.qxp_Morphy Richards Instruction Book 25/08/2021 14:39 Page 12

Temperature guide

Heat setting markings on the temperature dial of all Morphy Richards irons match those of the International Textile Care Labelling Code
Garment Symbol
Temperature Do not iron
Steam level setting
(see step 5 of 'Using
the Steam Generator'
Fabric
Ironing
Steaming
Without steam

Before use

Remove any protective cover from the soleplate (5) and the base
unit (16).
Unwind and straighten the power cord and steam supply cord.

Location

Locate the steam generator horizontally on the iron rest plate of
your ironing board (if large enough) or on a heat resistant stand
at the same height as your ironing board or below it. Always
ensure the steam generator is on a firm surface when ironing.
WARNING: Do not use the product on a surface which could
be damaged by heat or steam such as a worktop or a polished
wood surface.
If in doubt, contact Morphy Richards.
12
(120°C Max) Cool (160°C Max) Warm
IntelliTemp setting
No steam Low
(see 'Dry ironing')
Nylon, Acetates, Wool, Polyester
synthetic fabrics mixtures
Iron on wrong side, if
moisture required, use
damp cloth
(not Acetate)

Using the Steam Generator

Remove the detachable water tank (11) by pulling the water tank
handle (10), and fill with water through the filling aperture (1) to
the max fill line. Replace the water tank.
IMPORTANT : Never fill the dirty water chamber (2).
IMPORTANT : FOR EXTRA PROTECTION AGAINST
LIMESCALE, USE A MIXTURE OF 50% TAP WATER MIXED
WITH 50% DEIONISED, DISTILLED OR DEMINERALISED
WATER (AVAILABLE AT MOST LARGE SUPERMARKETS).
NEVER USE MORE THAN 50% DEIONISED, DISTILLED OR
DEMINERALISED WATER AND NEVER USE SCENTED
WATER OR IRONING WATER.
Never use battery topping up fluid or water containing any
substances like starch, sugar, fragrant additives or defrosted
water from a refrigerator.
NOTE: Please see point 2 of 'Exclusions' .
Re-filling during use 2
If the water level is too low, the unit will not produce steam. If this
happens, refill the detachable water tank (11) with water.
Plug the appliance into a mains outlet. Press the On/Off power
button (22), it will beep and the low steam level indicator (24a)
will flash.
(210°C Max) Hot MAX setting
Medium / High High
Cotton, Linen Rayon,
Rayon mixtures
Fabrics requiring
this setting usually
require steam pressing.
1