Table of Contents
Advertisement
2
CH A P T E R
Installing and Cabling Enclosures
This chapter describes how to install and cable enclosures in a standard 19-inch EIA
rack cabinet.
Before you begin installing the system, you must prepare the site as described in the
site planning guide and learn of any late-breaking information in the release notes
for your system.
Required Tools
The installation procedures in this chapter require the following tools:
#2 Phillips screwdriver
■
Allen wrench (provided; used with 6-mm screws)
■
Antistatic protection devices
■
Safety Precautions
For your protection, observe the following safety precautions when setting up your
equipment:
Install the system in accordance with the local safety codes and regulations at the
■
facility site. Follow all cautions and instructions marked on the equipment.
Ensure that the voltage and frequency of your power source match the voltage
■
and frequency inscribed on the equipment's electrical rating label.
Never push objects of any kind through openings in the equipment. Dangerous
■
voltages may be present. Conductive foreign objects could produce a short circuit
that could cause fire, electric shock, or damage to your equipment.
Note –
vendor is not responsible for the safety or regulatory compliance of a modified
product.
Do not make mechanical or electrical modifications to the product. The
13
Advertisement
Table of Contents
