Cisco Nexus 7010 Series Installing page 18

Installing the Front Doors and Frame Assembly
2. For each of the two front doors, match the two alignment pins on the door frame to the alignment holes
on the chassis. Position each door frame immediately under the cable management area (see
Installing the Front Doors, on page
3. Tighten three screws for each door frame (see
page
DETAILED STEPS
Step 1 Align the bottom frame assembly so that its four screw holes align to screw holes in the bottom of the chassis, and then
screw in four M4 x 6 mm screws to attach the bottom frame to the chassis (see
on page 19).
Installing a Cisco Nexus 7010 Chassis
18
21).
20).
Figure 13: Attaching the Door Frames to the Chassis, on
Installing a Cisco Nexus 7010 Chassis
Figure 11: Installing the Bottom Frame,
Figure 12: