Assembly; Adjust The Handle Bar; Add Oil To Engine; Fill The Fuel Tank - Echo WT-1610SP Operator's Manual

2

ASSEMBLY

Section

2.1 ADJUST THE HANDLE BAR

1. Open shipping box and remove packing material.
2. Loosen T-handles on handle bar. Raise upper portion
of handle bar to desired position. Tighten T-handles.
3. Cut the two corners of the shipping box so that the
trimmer can be rolled out onto the floor.
4. Install recoil rope into recoil loop on handlebar.
5. Rotate recoil loop to make contact with handle bar
and capture recoil rope.

2.2 ADD OIL TO ENGINE

Check the oil level and, if needed, fill the engine crankcase
with the type and amount of oil specified in the engine
owner's manual.
4

2.3 FILL THE FUEL TANK

not fill the fuel tank while the engine is hot or running,
since spilled fuel could ignite if it comes in contact
with hot parts or sparks from ignition. Do not start the
engine near spilled fuel. Never use fuel as a cleaning
agent.
DO NOT MIX OIL WITH FUEL.
Use only those types of fuels that are recommended in
your engine owner's manual.
To add fuel:
1. Stop engine, wait for all parts to stop moving and
disconnect spark plug wire. Allow the engine and
muffler to cool for at least three minutes.
2. Clean area around fuel fill cap and remove cap.
3. Using a clean funnel, fill fuel tank to 1/2" below bottom
of filler neck to provide space for any fuel expansion.
Install fuel fill cap securely and wipe up any spilled
gasoline.
WHEELED TRIMMER
WARNING
Gasoline and diesel fuels are highly
flammable and their
explosive. To prevent personal injury or
property damage:
Store fuel only in approved containers,
in well ventilated, unoccupied buildings,
away from sparks or flames. A container
with a capacity of 2 gallons or less with
a pouring spout is recommended. Do
vapors are