Burner Tube Cleaning Or Replacement - Weber 320 Owner's Manual

BURNER TUBE CLEANING OR REPLACEMENT

You will need a flathead screwdriver.
A) Your Weber ® gas barbecue must be OFF and cool.
B) Turn gas OFF at source.
C) Open lid and remove the cooking grates.
Burner Tube Removal
A) Remove the 1/4 x 20 inch screw that holds the burner tube to the cookbox (1).
B) Rotate the outside burner 90°. Slide and lift burner away from burner orifice and
remove from cookbox.
C) Repeat this procedure for the inside burner (2).
m CAUTION: Care must be taken when removing or
reinstalling burner tubes. Do not force or bend the gas lines
that connect the burner tubes to the control valve (3).
Burner Tube Cleaning
A) Look inside each burner with a torch (4).
B) Clean the inside of the burners with a wire (a straightened-out coat hanger will
work) (5).
C) Check and clean the air shutter opening at the ends of the burners (6). Check and
clean the valve orifices at the base of the burner valves (7). Use a steel bristle brush
to clean outside of burners. This is to make sure all the burner ports are fully open.
m CAUTION: Do not enlarge the burner ports when cleaning.
D) Lightly tap the burner to get debris and dirt out of the burner tube. Once the Spider/
Insect screen and burner is clean reinstall the burner.
Burner Tube Reinstallation
A) To reinstall the burner tubes, perform steps for "Burner Tube Removal" in reverse
order, as previously described. Check for proper assembly before fastening burner
tubes in place.
m CAUTION: The burner opening (8) must be positioned
properly over the valve orifices (9).
m WARNING: After reinstalling the burners, the gas
connections should be leak checked with a soap-and-water
solution before using the barbecue. Refer to "CHECK FOR
GAS LEAKS."
◆
mAINTENANcE
3
4
5
1
8
WWW.WEbER.cOm
2
6
7
9
® 35