Advertisement
How to Lock Your Lap and Shoulder Vehicle Seat Belt
Sliding Latch Plate and Switchable Retractor
A latch plate that slides freely on the belt webbing and cannot,
by itself, hold the belt snug around a car seat.
When installing the car seat, route the vehicle seat belt through
the proper belt path and buckle it in. Slowly pull the shoulder
belt all the way out to switch it to locking mode. Then, as
you pull the vehicle seat belt tight, feed all the slack back into the
retractor.
Grab the sides of the seat at the belt path and slide the seat
side-to-side and front-to-back. The seat should not move more
than 1" (2.5 cm).
Note: When using the lock-off, you are not required to switch
the retractor as an installation step. The lock-off locks the seat
belt. However, it is recommended to switch the retractor after
the installation is complete to avoid a possible strangulation risk.
• When using the Snuglock
belt into the proper belt path under the lock-off and buckle.
Push down firmly on the center of the seat while pulling on
the shoulder belt to remove the slack. Do not pull on the
strap with excessive force. Close the Snuglock
Test for tightness. Slowly pull the shoulder belt all the way
out to switch it to locking mode.
90
lock-off, route the vehicle seat
®
lock-off.
®
Advertisement
