Advertisement
Remove the plastic tape from the battery slot to begin using the Remote Control.
Tapping
Press for 1 sec
Double Tapping
Press and Hold
Power On
Deep Sleep
NOTE:
You can control the headset using the Remote Control only after you pair them together.
1st Friend
2nd Friend
3rd Friend
Save to preset while scanning
Configuration Menu
Connect the headset to your computer via a USB cable. Launch the Sena Device Manager and click DEVICE SETTING to configure the headset settings.
For details about downloading the Sena Device Manager, please refer to the leaflet included in the package.
If the Remote Control becomes disconnected with your headset, replace the Remote Control's battery or go through the pairing process again. Meanwhile, you can use the headset control buttons to operate the headset. Please refer to the User's Guide at www.sena.com for details on headset control button operations.
If you want to restore the 10U to factory default settings, use the Factory Reset in the configuration menu. The headset automatically restores the default settings and turns off.
If the 10U is not working properly for any reason, reset by gently pushing the pin-hole reset button located on the left speaker.
Sena Technologies, Inc.
www.sena.com
Customer Support: support.sena.com
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the 10U for Shoei Neotec that isn't answered in the manual? Leave your question here.