Related Manuals for Vetek ERT DYNALINK
Summary of Contents for Vetek ERT DYNALINK
- Page 1 Technical manual TECHNICAL MANUAL ERT DYNALINK With optional remote display Hantverksvägen 15, Nordens största webbshop för vågar Tel. +46 (0)176-208920 Technical_Manual_ERT_V2 76493 Väddö, Sverige www.vetek.se Email info@vetek.se...
- Page 2 〖AddrL〗 [ENTER] Address code low 4bits,Used for wireless net, sole instrument don’t adjust 〖CCCCC〗 [ENTER] press [ZERO] to adjust digit, press [TARE]to move digit 〖pAirH〗 [ENTER] Pair code high 4bits,Used for wireless net, sole instrument don’t adjust www.vetek.se Email info@vetek.se...
- Page 3 [ENTER] Display the value after calibration, add one digit 〖 XXX〗 [TARE] Sub 1 digit, display normal data Save DYNALINK Default setting and calibration data for user maintenance OFF handle instrument first, then press[PEAK]、[MODE]、[ON/OFF] key 3 seconds www.vetek.se Email info@vetek.se...
- Page 4 〖pAirH〗 [MODE] Pair code high 4bits,Used for wireless net, sole instrument don’t adjust 〖H0000〗 [MODE] press [ZERO] to adjust digit, press [TARE]to move digit 〖pAirL〗 [MODE] Pair code low 4bits,Used for wireless net, sole instrument don’t adjust www.vetek.se Email info@vetek.se...
- Page 5 If the DYNALINK’ s parameter were changed by wrong operation. User can recall company’s default value: Switch off DYNALINK, then press[ZERO], [TARE] and [ON/OFF] key 3 seconds on DYNALINK overlay. The default value will be load into DYNALINK www.vetek.se Email info@vetek.se...