Table of Contents
Advertisement
WIRED CONTROLLER (Continued)
3.15 46°F Vacation mode
• 46°F Vacation ON: Press FUNCTION under on state
of the unit till the unit enters the 46°F Vacation mode
setting interface. Press SWING/ENTER to confirm the
setting.
• 46°F Vacation OFF: When the 46°F Vacation mode is
activated, press FUNCTION to enter the 46°F Vacation
mode setting interface. After that, press SWING/
ENTER to cancel this function.
NOTE:
1.
This function is only available in heating mode.
2. When this function has been set, set temperature
is displayed as 46°F(8°C). In this case, temperature
setting and fan speed setting are shielded.
3. This function will be cancelled when switching
modes.
4. This function and sleep function cannot be on
simultaneously. If 46°F Vacation mode is set at
first and then sleep/quiet function is set after,
46°F Vacation mode will be cancelled while sleep
function will be activated, and vice versa.
Turn on the unit,without turning
Press "FUNCTION" button into
on 46°F Vacation mode
46°F Vacation mode
Press "SWING/ENTER" button to
turn 46°F Vacation mode
Fig. 18
Fig. 18 46°F Vacation mode Setting
46°F Vacation mode Setting
C ASS E T T E B S E R I ES OW N E RS M A N UA L - I ND OOR UN I T
• I-Demand on: Press and hold FUNCTION when the
• I-Demand off: When the I-Demand function is
NOTE:
1.
2. When this function has been set, set temperature
3. This function will be cancelled when switching modes
4. This function and sleep function cannot be on
• "Gree+" APP can be used to control it. Please scan
• When using the APP for the first time, please reset the
Press "SWING/ENTER" button to turn
on 46°F Vacation mode
• If there is a communication failure for WiFi, after
Press "FUNCTION" button into
46°F Vacation mode
3.16 I-Demand Setting
unit is "ON" till the unit enters the I-Demand setting
interface. Press SWING/ENTER to confirm the setting.
activated, press FUNCTION to enter the I-Demand
setting interface. After that, press SWING/ENTER to
cancel this function.
This function is only available in cooling mode.
is displayed as SE. In this case, the unit will adjust
the set temperature automatically to the factory
setting and fan will be at lower speed.
simultaneously. If I-demand function is set at
first and then sleep/quiet function is set after,
I-demand function will be cancelled while sleep
function will be activated, and vice versa.
3.17 WiFi Function Setting
the QR code to download it. APP can only set some
common functions of WiFi wired controller: ON/OFF,
mode, set temperature, FAN speed, etc.
WiFi function of remote controller (reset WiFi to ex-
factory setting): Under off status, press "FUNCTION"
+ "FAN" combination buttons on the wired controller
for 5s. Once "oC" is displayed, this indicates that reset
was successful.
resetting WiFi, the temperature display area of wired
controller displays "JF" for 5 seconds, which indicates
that the current reset is invalid.
| 1 4
Advertisement
Table of Contents
