Table of Contents
Advertisement
WIRED CONTROLLER (Continued)
3 Operation Instructions
3.1 ON/OFF
Press ON/OFF to turn the unit ON, press again to turn
the unit OFF.
NOTE:
• The state shown in Fig.4 indicates the "OFF" state
once power is applied. The state shown in Fig.5
indicates the "ON" state of the unit.
3.2 Mode Setting
Under the "ON" state of the unit, press MODE to switch
modes in the following sequence:
Auto-Cooling-Dry-Fan-Heating.
3.3 Temperature Setting
• Press
or
to increase/decrease the preset
temperature. If either is pressed continuously, the
temperature will be increased or decreased by 1°F(1
every 0.5s, as shown in Fig.6.
• In Cooling, Dry, Fan or Heating mode, the temperature
setting range is 61°F~86°F (16
• In the Auto mode, the setting temperature is unadjustable.
C)
o
C~30
C).
o
o
C A SS E T T E B S E R I ES OWN ERS M A N UAL - I N D OOR UN I T
3.4 Fan Setting
Under the "ON" State of the unit, each time you press
FAN, the fan speed will change circularly as shown in
Fig.7.
3.5 Timer Setting
• Under the "T-ON | T-OFF" state of the unit, press
Timer to set timer off/on.
• Timer ON setting: press Timer, and then LCD will
display "xx.x hour", with "hour" blinking. Then, press
or
to adjust the timing value. Then press SWING/
ENTER to confirm the setting.
• Timer OFF setting: press Timer, if LCD doesn't display
xx.x hour, it indicates the TIMER setting is canceled.
• Timer OFF setting when the unit is turned on is shown
as Fig.8.
• 0.5hr. If either is pressed continuously, the set time
will increase/ decrease by 0.5hr every 0.5s
| 1 1
Advertisement
Table of Contents
