BaByliss 2735E - Brushing 1000 Manual

Please carefully read the instructions for use below before using the appliance.

PRODUCT FEATURES

1. BE LISS straightening head with Tensio Control System^® 4 settings: 1. waves, 2. loose curls, 3. tight curls, 4. very tight curls
2. 50mm rotating boar-bristle head with Ceramic coating
3. 20mm round boar-bristle brush
4. Concentrator
5. Power 1000W
6. Ionic technology: shine and antistatic
7. Two directions to turn the rotating head
8. 2 temperature settings + 'cool-air' position
9. Hinged rear filter
10. Swivel cord
11. Storage pouch

INSTRUCTIONS FOR USE

Preparing your hair before straightening or blow-drying

1. After shampooing your hair, towel dry and untangle it carefully with a large-toothed comb.
   Advice from the hairstylist
   Always start untangling your wet hair at the tips, then gradually work your way up. Gentle untangling prevents split ends from forming.
2. Pre dry your hair using the BE Liss brushing without attachment and leave it damp.
   Advice from the hairstylist
   • To give your hairstyle more volume, pre-dry your hair with your head bent forward to lift the roots better.
   • However, if you would rather have less volume, hold your head straight when pre-drying.
3. Work in steps:
   • Use clips to separate your combed and untangled hair into sections about 2cm wide.
   • Lift the upper sections of your hair and pin to the top of your head to begin with the sections of hair at the nape of the neck and the sections underneath. Continue with the sections at the back of the head and then the sections on the side. Finish with the sections on the top.
   • Carefully work on the sections one at a time either with the straightening head, with the rotating head, with the smallest round brush or with the concentrator depending on the length of hair and the desired hairstyle.

Attaching and removing the accessories

To attach the head (straightening or rotating), the small diameter round brush or the concentrator to the body of the unit, line up the guides of the two parts and press until you hear a click.

To remove the brush, press on the unlocking buttons located on the sides of the unit and gently pull the accessory off.

THE BE LISS STRAIGHTENING HEAD

Perfect straightening and shine!

• Select the tension for your hair type using the Tensio Control System^® (1. waves, 2. loose curls, 3. medium curls, 4. tight curls)
  

Advice from the hairstylist

• When using the straighteners for the first time, select tension setting 1 (the lowest setting) to become familiar with the BE Liss straightening head.
• Then gradually increase the setting until you find the tension that works best with your hair.

Careful! Whatever straightening you adopt, we recommend holding the tips of the section to be straightened with your free hand so that you can keep your hair evenly distributed between the teeth of the straightening head. And before each stroke make sure the thin section is properly positioned with the roots at the base of the comb, then slowly and steadily slide the unit down the length of hair while holding the tips with your free hand.

Two directions to turn the rotating head

To roll the section of hair around the rotating head automatically, press the button for the desired direction (right or left) and hold throughout the blow-drying. The right or left rotation corresponds to the handling as well as to the desired effect of blow-drying under or out. To stop rotating, release the button.

MAINTENANCE

• Unplug the unit and allow to cool completely before cleaning or storing.
• We recommend cleaning the straightening and rotating heads, and the brush regularly, to prevent accumulation of hair, styling products, etc. Use a comb to remove hair from the rotating head and the small brush. Use a dry or very slightly dampened cloth for the plastic and ceramic surfaces.

BABYLISS
99 avenue Aristide Briand
92120 Montrouge
France
www.babyliss.com