BaByliss AS121E - 1200W MultiStyle Manual

Please read the safety instructions before use.

PRODUCT FEATURES

1. BE LISS straightening head with Tensio Control System^® 4 settings: 1. waves, 2. loose curls, 3. tight curls, 4. very tight curls
2. 38mm thermal brush with ceramic coating
3. 20mm round boar-bristle brush
4. 25mm round brush
5. Power 1200W
6. Ionic technology: shine and antistatic
7. Cool air button: sets the hairstyle
8. 3 speeds
9. Hinged rear filter for easy maintenance and extended life of the unit.
10. Swivel cord

FITTING AND REMOVING THE ATTACHMENTS

Fit the brushes and the straightening head onto the body of the unit by lining up the guides on the two parts and then press the two together until you hear a click.

To remove an attachment, press on the unlocking buttons located on the sides of the unit and gently pull the attachment off.

USE

The brush has 4 settings: 0 (off), I (low), II (medium) and III (high). The low setting is ideal for fine hair, the high setting for thicker hair. The separate 'cool air' button makes it easy to use a shot of cool air at the end of straightening or blow-drying to set the movement of each section and give it a 'long-lasting' effect.

Use your hot air straightening brush on pre-dried, slightly damp hair that is completely tangle free.

Use clips to separate hair so that you can work on one section at a time. Start with the sections underneath. Sections should be a maximum of 2cm wide and as even as possible. Always work from the roots to the tips and slide the brush slowly down the length of the section.

THE BE LISS STRAIGHTENING HEAD

Perfect straightening and shine!

• Select the tension for your hair type using the Tensio Control System^® (1. waves, 2. loose curls, 3. medium curls, 4. tight curls)
  

Advice from the hairstylist

• When using the straighteners for the first time, select tension setting 1 (the lowest setting) to become familiar with the BE Liss straightening head.
• Then gradually increase the setting until you find the tension that works best with your hair.

Careful! Whatever straightening you adopt, we recommend holding the tips of the section to be straightened with your free hand so that you can keep your hair evenly distributed between the teeth of the straightening head. And before each stroke make sure the thin section is properly positioned with the roots at the base of the comb, then slowly and steadily slide the unit down the length of hair while holding the tips with your free hand.

THE 38MM THERMAL BRUSH WITH CERAMIC COATING

FOR PERFECT GLIDE AND TO OFFER YOUR HAIR BETTER PROTECTION

The combination 'brush/hair dryer' will revolutionise your blow drying!

This ideal diameter, recommended by BaByliss, creates a smooth movement and adds body to your hair without tangling it and for the best blow-dry results for hair full of softness.

The hot air of the unit heats the metal barrel of the attachment. The heat is thus distributed directly over your hair making it soft and smooth.

THE 20MM ROUND BOAR-BRISTLE BRUSH

This size is more specially suited for the finishing touches: this brush will accentuate the shaping of certain sections like the fringe, the tips or the roots.

The use can also vary according to the length of your hair:

• on short hair, it can be used horizontally, like the thermal brush, for gentle and natural blow-drying with the ends flicked out or turned under
• on long hair, it can be used vertically for a spiral curl effect at the tips

THE ROUND STYLING BRUSH

This brush can be used on dry or damp hair and is perfect for curling and adding body to your hair!

Take up a section of hair, brush it from the roots to the tips with the brush then coil the hair around it. Hold for 15 to 20 seconds depending on the thickness of the section. Let the hair cool before combing it out.

MAINTENANCE OF THE UNIT

• Unplug the unit and allow to cool completely before cleaning or storing.
• We advise you clean the straightening head and brushes regularly to avoid build-up of hair, styling products, etc. Use a comb to remove hair from the brushes. Use a dry or very slightly damp cloth for the plastic and ceramic surfaces.

BABYLISS
99 avenue Aristide Briand - 92120 Montrouge - France
www.babyliss.com