Table of Contents
Advertisement
3.
Here it is possible to select which source (DAB/FM/Network/No update) the unit uses to obtain and
update the time and date. If "Update from Network" selected, proceed to the next step to select time
zone to ensure that the time is displayed correctly. And then select the "Daylight savings" is [ON] or
[OFF].
4.
In the next step you can specify whether the product should remain connected to the Internet when on
standby. Turn the SCROLL/SELECT dial on the unit or press S / 8 buttons on the remote to select [YES],
then press the SCROLL/SELECT dial on the unit or press SELECT button on on the remote to confirm.
5.
Your radio will now scan for your wireless network, this may take a few seconds then a list of all the
wireless networks will appear on the screen. Select the WLAN network you know and whether to use
WPS (Push Button/Pin) or Skip WPS to enter the password using the displayed keyboard.
Connecting using the WPS button on your router
Connecting using the WPS (Wi-Fi Protected Setup) button on your router is a quick and easy way to connect
your radio without having to type in a password. Select one of the following connection methods:
Push Button
-
If your router has a WPS button you will notice [WPS] at the front of your network name.
Press ▶" ^/▼ □ buttons to select Push Button, then press SELECT button to confirm.
6.
7.
You will now see a message on the screen telling you to press the WPS button on your router. Press the
WPS button on your router. Check your routers instruction manual if you are unsure which button is the
WPS button.
8.
Press the SELECT button to confirm. Your radio will now connect to your router, this may take a few
seconds.
Pin (code number)
-
The radio generates an 8-digit code number. Enter this code number into the wireless router or access
device.
Connecting using your wireless network password
If your router has not got a WPS button you will now be asked to enter your wireless network password, or
you can select SKIP WPS which also take you to the password screen.
Press ▶" ^ / ▼ □ / S / 8 buttons to select each letter/number of your password. Then press SELECT
9.
button to enter the selected letter/number.
When you have entered your password, Press ▶" ^ / ▼ □ / S / 8 buttons to select OK on the right
10.
of the screen.
11.
After your radio has connected, press SELECT button to exit the setup.
Settings can be changed at any time in Menu-System Settings - Network -
Network Wizard
This instruction manual explains the basic instruction for operating this unit. Unless
otherwise stated, all operations described are based on remote control use.
System Settings
Press the MENU button on unit or remote control to display the menu. Turn SCROLL/SELECT dial on unit
or ▶" ^/▼ □ buttons on remote control to select System Settings, then press SCROLL/SELECT dial on
unit or SELECT button on remote to confirm.
GB-6
Advertisement
Table of Contents
