Table of Contents
Advertisement
Remote Control Operation Range
The remote control sensor on the front unit is sensitive
to the remote control's commands up to a maximum of
4 metres away and within a maximum of 60° arc.
NOTE: The operating distance may vary depending on
the brightness of the room.
Connection
1.
The audio input/output (analogue), optical out (digital) and coaxial out (digital) are available on the
back of the unit to connect A/V amplifier or HiFi system.
2.
Connect the antenna included in the supply to the antenna connection and extend it to the desired
length.
3.
Connect the WLAN antenna included in the supply to the W-LAN socket at the back of the unit for WIFI
connection.
4.
Unwind the mains cable to its full length. Connect the mains plug to the mains socket. The unit is now
connected and ready to use
Be sure to connect the power cord to an AC outlet that supplies the correct voltage.
Hold the power plug when plugging it into an outlet or unplugging it. Never pull or yank
on the power cord.
5.
To switch the unit off completely, unplug the mains cable from the mains socket.
Network Connection
This product only supports wireless network connection for network access and did not support wired LAN
connection.
Wireless Network
1.
Check first of all whether the control lamps (LINK/ACT) of your router light up.
2.
Proceed with the operations described in the below "Getting Started". It is recommended to run
through the setup wizard in the System Settings section.
This unit cannot be connected to a standalone modem directly. A router or a modem
incorporated with a router has to be used.
Since there are various connection configurations, please follow the specifications and
instructions of your telecommunication carrier, Internet Service Provider and Router
Setting Guidebook.
GB-4
Advertisement
Table of Contents
