Lexmark C720 Setup Manual page 38

Hard disk connector
34 Install memory and network options
3
Align the ribbon cable connector to the
connector pins on the hard disk.
The connector ends on the ribbon cable
slightly differ from each other. The connec-
tor end that has pin holes not drilled is the
connector that attaches to the hard disk.
4
Push the cable connector onto the hard
disk.
5
Align the screw holes in the hard disk with
the holes on the mounting plate.
Make sure the hard disk connector and
notch on mounting plate are aligned as
shown.
6
Insert the four screws into the holes on the
mounting plate.
7
Gently tighten the screws to secure the
hard disk to the mounting plate.
Notch