Kohler T-Bolt K-3900 Installation Manual page 16

Speaker
Connections
Docking
Station Cord
7. Connect the Water Supplies and Docking Station
Connect the water supply hose to the supply stop.
Connect the docking station power cord.
Connect the optional external FM antenna (not shown) to the toilet if it is installed.
Connect the external speaker wires (not shown) to the toilet if external speakers are installed.
IMPORTANT! The remote control will not function when removed from the docking station until it has
charged for approximately 30 minutes. Flush the toilet manually or use the remote control while it is
attached to the docking station using the buttons on the toilet until the remote control is fully charged.
Place the remote control on the docking station.
Turn on the water supply.
Connect the power.
Check for Leaks
NOTE: Once the power is connected, the toilet will automatically enter start-up mode. This process takes
several minutes.
NOTE: If there is a failure during start-up mode, follow the directions on the remote control.
Once the start-up sequence has been completed flush the toilet using the manual buttons on the side
of the toilet.
Let the toilet fully refill and check for leaks.
Secure the Toilet
1132337-9-B
FM Antenna
Connection
Wall Supply
Installation Shown
16
Docking
Station Cord
Kohler Co.