Helion DOMINUS10TR HLNA0184 Owner's Manual And Exploded Views

Helion DOMINUS10TR HLNA0184 Owner's Manual And Exploded Views

1/10th scale 4x4 brushless powered electric truggy

Advertisement

Quick Links

FOR HLNA0184
OWNER'S MANUAL AND EXPLODED VIEWS
LENGTH
477mm (18.78in)
WIDTH
320mm (12.6in)
HEIGHT
180mm (7.08in)
WHEELBASE
300mm (11.81in)
WHEEL DIAMETER
66mm (2.6in) x 44mm (1.73in)
TIRE DIAMETER
F/R: 120mm (4.72in) x 60mm (2.36in)
WHEEL OFFSET
12mm Hex
WEIGHT*
2350g (5.18lb)
BATTERY
1,800mAh NiMH 7-CELL, 8.4V
MOTOR
RADIENT REAKTOR BRUSHLESS SENSORLESS 3500kV
RADIO
HRS-3.1 2.4GHz 3-CHANNEL
CHARGER
AC WALL TRICKLE
*APPROXIMATE OUT-OF-THE-BOX WEIGHT
• Entire contents ©2012 Helion RC
• Before using your product, review all documentation and inspect the products carefully. If for some reason you decide it is not
what you wanted, then do not continue with unpacking, setup or operation of your product. Your local hobby dealer cannot ac-
cept a product for return or exchange after partaking in actions that produce wear and tear.
• Read, understand and follow all instructions and accompanying material carefully before operating or assembling your vehicle
to prevent serious damage to your vehicle. Failure to complete these tasks properly or intentional aversion to the content will be
considered abuse and/or neglect.
• Product specifi cations are subject to change without notice. Due to ongoing development, the actual product may vary from
images shown.
• This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
• This product is not a toy! (14+) Recommended for ages 14 and up. Adult supervision required for ages under 18 years old.
Contains small parts, keep out of reach of children 3 years of age and younger.
1/10th SCALE 4x4
BRUSHLESS POWERED
ELECTRIC TRUGGY
POWERED BY

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DOMINUS10TR HLNA0184 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Helion DOMINUS10TR HLNA0184

  • Page 1 *APPROXIMATE OUT-OF-THE-BOX WEIGHT POWERED BY • Entire contents ©2012 Helion RC • Before using your product, review all documentation and inspect the products carefully. If for some reason you decide it is not what you wanted, then do not continue with unpacking, setup or operation of your product. Your local hobby dealer cannot ac- cept a product for return or exchange after partaking in actions that produce wear and tear.
  • Page 2: Package Contents

    Patience while reading thoroughly through all of the instructions and guides that will help ensure you get the most out of your new Helion RC product. RECOMMENDED TOOLS (NOT INCLUDED) Please use caution and follow the manufacturer’s recommended operating instructions for these items and always wear eye protection.
  • Page 3: Getting Started

    1/10th SCALE 4x4 BRUSHLESS POWERED ELECTRIC TRUGGY FEATURES OF THE DOMINUS 10TR • Steel ring and pinion gear type four wheel drive drivetrain. • Adjustable suspension, camber, and front toe. • Radient Reaktor brushless waterproof ESC and motor. • Pivot ball style front suspension with upper arm. •...
  • Page 4 PRECAUTIONS WHEN USING THE HRS-3.1 RADIO SYSTEM • Your model can cause serious damage or injury so please use caution and courtesy when operating your model. • Do not expose the radio system to water or excessive moisture. • As a safety precaution, perform all transmitter and receiver adjustments with the vehicle’s wheels off the ground. This ensures the complete control over the vehicle at all times during adjustments.
  • Page 5 1/10th SCALE 4x4 BRUSHLESS POWERED ELECTRIC TRUGGY HRS-3.1 BINDING AND FAIL SAFE SETTING Binding the Transmitter and Receiver: The process of allowing communication to occur between a 2.4GHz transmitter and receiver is called “binding” (sometimes referred to as “matching” or “pairing”). The radio system included with your product comes pre-confi gured and bound from the factory. In the event your system loses binding, one of the components has been replaced, or you choose to add an additional vehicle to your transmitter, you will need to bind the transmitter and receiver.
  • Page 6 HRS-3.1 CONNECTION AND CONFIGURATION... Receiver, ESC and Servo Connections: Generic wiring diagram. 1. Channel 1: Steering Servo 2. Channel 2: ESC (Throttle/Brake) Note: An easy way to remember this is 1 to turn, 2 to burn ( as in burn-out ). Digital Trim Settings: •...
  • Page 7 1/10th SCALE 4x4 BRUSHLESS POWERED ELECTRIC TRUGGY ...HRS-3.1 CONFIGURATION CONTINUED • Throttle and Brake End Point Adjustment (EPA) › Use this function to adjust throttle and brake travel adjustments. › Throttle Adjustment: » Pull the throttle trigger completely to full throttle and use the “TH+” or “TH-“ buttons to adjust the throttle end point to the desired location.
  • Page 8 HRS-3.1 STANDARD OPERATION » A third push forward ont he trigger will apply reverse throttle. » WARNING: Causing the vehicle to make quick transi- tions from forward/reverse motion to the opposite TURN LEFT TURN RIGHT direction using the throttle control can cause dam- age to your vehicle and electronics and will void the warranty.
  • Page 9 You can purchase an adapter from Ultra-Plug (F) to Tamiya style (F) from your local hobby dealer which will allow you to continue to use your included Helion battery after you have changed your main power connector.
  • Page 10: Safety Tips

    If you plan to run for extended periods of time in light or heavy rain It is recommended to secure the receiver in an additional waterproof membrane. Since the Helion HRS-3.1 receiver is a micro size receiver, fi tting it into a balloon is fairly easy.
  • Page 11 1/10th SCALE 4x4 BRUSHLESS POWERED ELECTRIC TRUGGY ...GENERAL CARE AND MAINTENANCE CONTINUED... b. Ensure there are no kinks in the antenna or antenna tube. c. Never fold the end of the antenna over the tube, this will reduce the range and damage the antenna. d.
  • Page 12: Storage And Disposal

    ...MAINTENANCE CONTINUED ii. When reinstalling tires, use caution when tightening the nuts that secure the wheels to the vehicle. Ensure the wheels rotate freely after installed but don’t wobble excessively. Over tightening the wheels may cause excess strain on the electrical and mechanical components of your vehicle.
  • Page 13: Troubleshooting Guide

    1/10th SCALE 4x4 BRUSHLESS POWERED ELECTRIC TRUGGY TROUBLESHOOTING GUIDE Problem / Symptom Possible Cause Possible Solution Battery voltage too low Charge battery Vehicle will not turn on Battery not connected Re/connect battery Damaged battery Replace battery Transmitter will not turn Battery voltage too low Charge or change batteries Battery/ies installed improperly...
  • Page 14: Differential Assembly

    DIFFERENTIAL ASSEMBLY HLNA0101 HLNA0118 HLNA0100 HLNA0104 HLNA0117 HLNA0200 HLNA0133 HLNA0201 HLNA0125 FRONT GEARBOX ASSEMBLY HLNA0202 HLNA0142 HLNA0147 HLNA0198 HLNA0129 HLNA0144 HLNA0246 HLNA0116 HLNA0099 HLNA0199 HLNA0201 HLNA0119...
  • Page 15 1/10th SCALE 4x4 BRUSHLESS POWERED ELECTRIC TRUGGY STEERING HUB AND FRONT SUSPENSION ARM ASSEMBLY RIGHT HLNA0110 HLNA0111 HLNA0109 HLNA0119 HLNA0118 HLNA0080 LEFT HLNA0081 REAR HUB AND REAR SUSPENSION ASSEMBLY HLNA0113 HLNA0083 LEFT HLNA0112 HLNA0127 HLNA0119 RIGHT HLNA0118 HLNA0082...
  • Page 16 FRONT SUSPENSION AND BUMPER ASSEMBLY HLNA0080 HLNA0137 HLNA0213 HLNA0213 HLNA0094 HLNA0093 HLNA0113 HLNA0150 HLNA0081 HLNA0206 HLNA0117 HLNA0079 HLNA0069 HLNA0150 HLNA0145 HLNA0124 HLNA0142...
  • Page 17: Shock Assembly

    1/10th SCALE 4x4 BRUSHLESS POWERED ELECTRIC TRUGGY SHOCK ASSEMBLY HLNA0084 HLNA0087 HLNA0090 HLNA0090 HLNA0085 HLNA0089 HLNA0085 HLNA0091 (FRONT) HLNA0091 HLNA0089 SHOCK SPRING INSTALLATION HLNA0088 HLNA0089 REAR FRONT...
  • Page 18: Front Shock Installation

    FRONT SHOCK INSTALLATION HLNA0127 HLNA0084 HLNA0146 STEERING BELL CRANK AND SERVO SAVER ASSEMBLY HLNA0070 HLNA0070 HLNA0070 HLNA0115 HLNA0116 HLNA0107...
  • Page 19 1/10th SCALE 4x4 BRUSHLESS POWERED ELECTRIC TRUGGY STEERING RACK INSTALLATION HLNA0137 HLNA0070 HLNA0127 SERVO ASSEMBLY HLNA0207 HLNA0058 HLNA0144 HLNA0070 HLNA0128 HLNA0074 HLNA0070...
  • Page 20: Motor Mount Assembly

    MOTOR MOUNT ASSEMBLY HLNA0224 (13T) HLNA0149 HLNA0148 RDNA0021 HLNA0123 HLNA0066 ELECTRONICS INSTALLATION HLNA0144 HLNA0070 HLNA0210 HLNA0211 HLNA123 HLNA124...
  • Page 21 1/10th SCALE 4x4 BRUSHLESS POWERED ELECTRIC TRUGGY SERVO TIE ROD INSTALLATION HLNA0144 HLNA0075 HLNA0137 HLNA0141 REAR INPUT AND SPUR GEAR SHAFT ASSEMBLY HLNA0201 HLNA0119 HLNA0123 HLNA0117 HLNA0247 HLNA0116 HLNA0119 HLNA0134 HLNA0152 HLNA0061 HLNA0099...
  • Page 22: Rear Gearbox Assembly

    REAR GEARBOX ASSEMBLY HLNA0143 HLNA0147 HLNA0144 HLNA0202 HLNA0198 HLNA0199 HLNA0199 REAR BUMPER ASSEMBLY HLNA0204 HLNA0203 HLNA0202 HLNA0129 HLNA0203 HLNA0203...
  • Page 23: Rear Suspension Assembly

    1/10th SCALE 4x4 BRUSHLESS POWERED ELECTRIC TRUGGY REAR SUSPENSION ASSEMBLY HLNA0082 HLNA0137 HLNA0205 HLNA0117 HLNA0150 HLNA0069 HLNA0079 HLNA0206 HLNA0206 HLNA0202 HLNA0124 HLNA0142...
  • Page 24 REAR GEARBOX INSTALLATION HLNA0213 HLNA0213 HLNA0112 HLNA0094 HLNA0113 HLNA0092 HLNA0152 HLNA0124...
  • Page 25 1/10th SCALE 4x4 BRUSHLESS POWERED ELECTRIC TRUGGY TOP PLATE, GEAR COVER, AND BATTERY INSTALLATION HLNA0146 HLNA0144 HLNA0152 HLNA0211 HLNA0210 REAR SHOCK AND TIRE INSTALLATION HLNA0127 HLNA0215 HLNA089 HLNA0228 HLNA0146...
  • Page 26 HELION SPARE PARTS LIST... HLNA0058 ..WATERPROOF SERVO, 42IN-OZ, 0.22SEC/60, PG, 1/10 ..................... HLNA0060 ..NIMH WALL CHARGER, 7-Cell, US-Tam Plug ........................HLNA0061 ..SPUR GEAR, 50T, 32P (DOMINUS) ............................. HLNA0066 ..MOTOR MOUNT (DOMINUS) .............................. HLNA0069 ..INNER HINGE PIN SET (DOMINUS) ............................. HLNA0070 ..STEERING BELL CRANKS (DOMINUS) ..........................
  • Page 27 HLNA0219 ..DOMINUS 10TR OWNER’S MANUAL AND EXPLODED VIEWS ....................HLNA0220 ..DOMINUS 10TR EXPLODED VIEW ............................HLNA0224 ..PINION GEAR, 13T, 32P, BRASS ............................HLNA0225 ..HELION HRS-3.1 2.4GHz 3-CHANNEL TRANSMITTER ......................HLNA0226 ..HELION HRS-3.1 2.4GHz 3-CHANNEL RECEIVER ....................... HLNS0228 ..SERRATED NUTS, FLANGED, M4 ............................
  • Page 28 1/10th SCALE 4x4 BRUSHLESS POWERED ELECTRIC TRUGGY HELION OPTION PARTS LIST HLNA0062 ..PINION GEAR, 14T, 32P, BRASS ............................HLNA0063 ..PINION GEAR, 15T, 32P, BRASS ............................HLNA0064 ..PINION GEAR, 16T, 32P, BRASS ............................HLNA0177 ..SLIPPER CLUTCH (DOMINUS) ............................HLNA0178 ..ALUMINUM WHEEL HEX SET (DOMINUS) ...........................

Table of Contents