AbleNet iTalk2 Quick Start Manual

Quickstart Guide:
iTalk2™ communicator
www.ablenetinc.com
3
Record Messages
a
a. Press and Hold a switch top, begin speaking when
you hear a beep. Release when finished.
b. Repeat for second location.
RECORD Light will flash while recording.
1
Insert Battery and Turn On
Connect one 9-volt battery at the bottom of the device.
Rotate the Volume ON/OFF knob to turn the device on.
iTalk2 includes a detachable Mounting Base that must be
removed to access the battery door. Press the tab and slide
to remove the base.
4
Exit Record Mode
b
Press and Release
Press and Release the RECORD button to exit Record
Mode.
NOTE: This device has 2 minutes of total recording time. The
light will turn yellow and flash when only ten seconds of time
remain.
2
On
Press and Hold the RECORD button until the RECORD
Light activates, then Release.
5
iTalk2 is now programmed and ready for use.
Enter Record Mode
Press and Hold,
then Release
Play Messages