AbleNet SuperTalker Quick Start Manual

Quickstart Guide:
SuperTalker™ progressive communicator
Overlays and ideas at www.ablenetinc.com
3
Enter Record Mode
Press and Hold,
then Release
Press and Hold the RECORD button until the RECORD
Light activates, then Release.
1
Powering SuperTalker
Power
Insert four AA batteries into the device as shown. Power
On/Off is located on the spine of the device.
4
Record Messages
Press and Hold
while speaking
Press and Hold the desired Message location, begin
speaking when you hear a beep. Release when finished.
Repeat for additional messages.
RECORD Light will flash while recording.
NOTE: Speak close to the microphone for loud, clear sound.
2
Select Level and Grid
Adjust as-needed
With the desired Overlay and Keyguard in place:
Select a LEVEL (1-8) and Grid (1, 2, 4, 8) using the
controls on the spine of the device.
NOTE: Be sure to match the Grid number to the Keyguard
and Overlay currently installed on the device.
For information on Overlays, Keyguards and Helpful Tips, see
reverse.
5
Exit Record Mode
Press and
Release
Press and Release the RECORD button to exit Record
Mode.
NOTE: This device has 16 minutes of total recording time.
The RECORD Light will turn yellow when only two minutes
remain.