Advertisement
Leakage Test
Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor area.
Connect the propane gas cylinder to the regulator and turn the control knob on the unit to the "OFF"
position. Spray a soap and water mixture on all connections. Turn the gas supply on. If bubbles occur on
any connection there may be a leak. If you smell gas or a leak is discovered, turn the gas valve
off. Disconnect propane gas cylinder and do not use the appliance until the leak is repaired.
Operation
To Light
1. Read instructions before lighting.
2. Control knob must be in the "OFF" position.
3. Connect propane cylinder(See Manual).
4. Push and turn control knob counter clockwise to High.
5. Use a match or a lighter to light the fire column. Once the burner is lit,Continue to
hold the control knob for another 10 seconds and release.
6. Adjust the flame to desired flame height with the control knob. CAUTION:
Disconnect Propane cylinder when this appliance is not in use.
Note:
Lava rocks could pop up and strike someone in the face during the process of lighting this unit.
Stand away from the unit for the first 20 minutes after igniting. Flame height should be a
yellow/blue color between 1-6 inches in height.
To Extinguish
1. Turn and push the control knob clockwise to the "OFF" position.
2. Disconnect propane cylinder.
If ignition does NOT immediately take place in seconds, push and turn the
control knob clockwise to "OFF", wait 5 minutes, and then repeat the lighting
procedure as above.
Care and Maintenance
Store the fire pit in a cool dry place away from direct sunlight.
The propane tank must be disconnected and removed from the fire pit before the fire pit can be stored indoors.
Use manufacturer approved or supplied replacement parts and accessories only. Use of unauthorized replacement parts
may void the warranty.
Keep the fire pit free and clear from combustible materials.
Visually inspect the burner ring for blockages (spider webs, dirt, etc.). Keep the fire pit free and clear from debris.
After the burner ring and lava rock are completely cooled down, use a soft brush to get rid of mild stains, loose dirt and soil. Wipe
with a soft cloth.
Limited Warranty
The manufacturer's warranty will be voided by, and the manufacturer disclaims any responsibility for the following actions:
Modification of the fire bowl and/or components including the gas valve assembly.
Use of any component part not manufactured or approved by the manufacturer.
Use and installation other than as instructed in this manual.
8
Advertisement
