Cleaning And Maintenance; What If There Are Problems; Disposal - Beurer BF 400 Instructions For Use Manual

9. Cleaning and maintenance

The device should be cleaned from time to time.
This should be done using a damp cloth and, if necessary, a small amount of detergent.
IMPORTANT
• Never use abrasive solvents or cleaning products!
• Never submerge the device in water!
• Do not clean the device in a dishwasher!

10. What if there are problems?

If the scale encounters an error during measurement, the following is displayed:
Display
U -
BF Err
oLd
Incorrect weight is dis-
played.
Incorrect weight is dis-
played.
Incorrect weight is dis-
played.
Lo
BF - - -

11. Disposal

Empty, completely flat batteries must be disposed of through specially designated collection boxes, recy-
cling points or electronics retailers. You are legally required to dispose of the batteries.
The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead
Cd = Battery contains cadmium
Hg = Battery contains mercury
For environmental reasons, do not dispose of the device in the household waste at the end of its service
life. Dispose of the device at a suitable local collection or recycling point in your country.
Dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic
Equipment). If you have any questions, please contact the local authorities responsible for waste
disposal.
Dispose of packaging in an environmentally friendly manner.
Cause
Unknown measurement as it
is outside the user assignment
limit or a unique assignment is
not possible.
The proportion of fat is outside
the measurable range (less
than 3% or greater than 65%).
Maximum weight capacity of
200 kg exceeded.
Surface scale is placed on is
not even and hard e.g. carpet.
Not standing still.
Incorrect zero point of scale.
The batteries in the scale are
flat.
BIA measurement not possible. Please repeat the measurement barefoot, or
Solution
Select your user by pressing the
buttons.
Please repeat the measurement barefoot, or
with the soles of the feet lightly dampened
if necessary.
Loads must not exceed 200 kg.
Place the scale on an even, hard surface.
Stand as still as possible.
Wait until the scale switches itself off. Acti-
vate the scale, wait for "0.0 kg" to appear
and take the measurement again.
Replace the batteries in the scale.
with the soles of the feet lightly dampened
if necessary. Remain on the stainless steel
electrodes after weight measurement, until
the body analysis values are displayed.
20
PAP
20
/