Table of Contents
Advertisement
Available languages
Available languages
Loop current measurement
e) Frequency
Press
to measure the frequency. Refer to the figure below for connecting the test leads.
Frequency measurement
f) Continuity
Press
to measure the continuity. Refer to the figure below for connecting the test leads.
OPEN
Continuity measurement
Note: The buzzer beeps if the resistance is less than 250 Ω.
10. Source (output mode)
If the calibrator is in "Measurement Mode", press
"SOURCE".
a) Millivolt
Press
to select millivolt output. Press
The figures below show millivolt output and how to connect the test leads.
34
Red
Black
Connection
Connection
Connection
to switch to "Output Mode" and the LCD will display
to choose output digit, then press
to set the value.
Advertisement
Chapters
Table of Contents
