Samsung AJ040TXJ2KG/EU Technical Data Book page 305

Free joint multi for europe r32, 50hz, hp
Table of Contents

Advertisement

13. Installation
CAUTION
• You have just purchased a system air conditioner
and it has been installed by your installation
specialist.
• This device must be installed according to the
national electrical rules.
• If your outdoor unit exceeds a net weight of 60 kg,
do not install it on a suspended wall, but stand it on
a floor.
When installing the outdoor unit at the seaside,
make sure that it is not directly exposed to sea
breeze. If you cannot find an adequate place free
from direct sea breeze, construct a protection wall
or a protective fence.
- Install the outdoor unit in a place (such as near
buildings etc.) where it can be prevented from
sea breeze. Failure to do so may cause a damage
to the outdoor unit.
Sea breeze
Sea
Outdoor Unit
• If you cannot avoid installing the outdoor unit at the
seaside, construct a protection wall around to block
the sea breeze.
• Construct a protection wall with a solid material
such as concrete to block the sea breeze. Make sure
that the height and the width of the wall are 1.5
times larger than the size of the outdoor unit. Also,
secure a space larger than 700 mm between the
protection wall and the outdoor unit for exhausted
air to ventilate.
Sea breeze
Sea
※ In case you want more information about the controllers and accessories, please refer to the Controller and Accessory TDB
on pvi.Samsung.com site or Global Partner Portal site.
Sea breeze
Sea
Outdoor Unit
Outdoor Unit
Protection wall
CAUTION
• Depending on the condition of power supply,
unstable power or voltage may cause malfunction
of the parts or control system. (At the ship or places
using power supply from electric generator...etc)
• Install the unit in a place where water can drain
smoothly.
• If you have any difficulty finding installation location
as prescribed above, contact your manufacturer for
details.
• Be sure to clean the sea water and the dust on the
heat exchanger of the outdoor unit and apply a
corrosion inhibitor on it. (At least once in a year.)
Minimum clearances for the outdoor unit
When installing 1 outdoor unit
300 or
600 or
more
more
300
or more
(Unit: mm)
2000 or
more
305

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents