Led Diagnostic Indicators - UNICOM Smart-Switch/801 User Manual

Smart-Switch/801

LED Diagnostic Indicators

Get user manuals: See SafeManuals.com
The Switch status can be easily monitored through panel indicators. If the
power indicator does not light when the power cord is plugged in, you
may have a problem with AC power outlet or power cord. However, if the
Switch powers off once running, Check for loose power connections,
power losses, or surges at the AC power outlet. If you still cannot resolve
the problem, contact your local dealer for assistance.
I
Improper Network Topologies
RJ-45 ports: Use unshielded twisted-pair (UTP) or shielded twisted-pair
(STP) cable for RJ-45 connections: Category 3, 5e or 6 cable for 10Mbps
or Category 5e and 6 cable for 100Mbps connections. Ensure that the
length of any twisted-pair connection does not exceed 100 meters ( 328
feet ).
100Base-FX fiber port: The Multi-Mode Fiber connector type must use
50/125 or 62.5/125µm MM fiber cable. You can connect two devices over
a distance of up to 2km. However, the Single Mode Fiber connector must
use 9/125µm Single Mode fiber cable. You can connect two devices up
to 30 kilometers apart in full duplex operation, utlilizing Single Mode
format.
18