Switch Output Do Mode Setting; Device Address - Ebyte M02-XACX0420 User Manual

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

4.2.2 Switch output DO mode setting

（1）Level pattern

Output according to the level set by the user. The switching characteristic of the level mode is

similar to the function of the self-locking switch。

（2）pulse mode

After switch output DO is turned on, keep the set pulse width time (unit ms), switch output DO

is automatically turned off. Pulse width setting range from 50 to 65535 (default 50)。

（3）Follow the pattern

After the user sets the following mode, the input port to follow is set. The DO output is

consistent with the DI input.

Note: You can set multiple switch output DO terminals to follow one DI input port, but cannot

set one switch output DO terminal to follow multiple DI inputs。

4.3.1 Device address

Device address composition: hardware address + software offset address

Figure 4-2-1 Switch output DO port

User Manual

【4AI+2DO】 MA02-XACX0420

Table of Contents