Product Function Introduction; Do Output; Level Output; Following Mode - Ebyte E870-W1 User Manual

Table of Contents

Chengdu Ebyte Electronic Technology Co., Ltd.

E870-W1 User Manual

4. Product function introduction

4.1.

Two-way A-type relay output is adopted, and the normally open contact and the common point are respectively led

out by 3.81 mm Phoenix terminals, which can shut off the maximum AC 250V / 7A and DC 30V / 7A .

The active reporting of DO acquisition signals can be turned on or off, and the active reporting function of DO

supports the configuration change reporting, periodic update, change reporting + periodic realization of the active

reporting function of the device;

Periodic reporting: report the current status according to the configured time period, the time interval can be

1-65535 , unit: minute;

Change report: that is, the DO status is reported once when the DO status changes, and the range needs to be

configured as a non-zero value.

Two-way A-type relay output is adopted, and the normally open contact and the common point are respectively led

out by 3.81 mm Phoenix terminals, which can shut off the maximum AC 250V / 7A and DC 30V / 7A .

The active reporting of DO acquisition signals can be turned on or off, and the active reporting function of DO

supports the configuration change reporting, periodic update, change reporting + periodic realization of the active

reporting function of the device;

Periodic reporting: report the current status according to the configured time period, the time interval can be

1-65535 , unit: minute;

Change report: that is, the DO status is reported once when the DO status changes, and the range needs to be

configured as a non-zero value.

according to the following source configured by the user (D I1 , DI2 , DI3 , D I4 , AI1, AI2, DO1, DO2), and

multiple outputs can follow the same follow-up source output. Simply put, it is to detect the state change of the

follow-up source , automatically output the relay with it as the following source. When the follow mode is turned

on, the follow source should be configured at the same time to use this linkage function.

Note: This function only supports local IO linkage

Table of Contents