Switch Output Do Mode Setting; Device Address - Ebyte MA02-AAC 2240 Series User Manual

2di + 2ai + 4do

Hide thumbs Also See for MA02-AAC 2240 Series:

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

4.3.2 Switch output DO mode setting

(1) Level mode

Output according to the level set by the user. The switching characteristics of the level mode are similar to the

function of a self-locking switch.

(2) Pulse mode

After the switch output DO is turned on, the set pulse width time (in ms) is maintained, and the switch output DO is

automatically turned off. The pulse width setting range is 50～65535 (default 50).

(3) Follow mode

After the user sets the follow mode, set the follow input terminal. The switch output DO terminal is consistent with

the DI input terminal.

Note: Multiple switch output DO terminals can be set to follow one DI input terminal, and one switch output DO

terminal can not be set to follow multiple DI input terminals.

4.4.1 Device address

Device address composition: hardware address + software offset address

The default device address is 32 (hardware address 31 + software address 1 = device address 32).

Device address setting range: 1～247.

Hardware address: realized by the dial switch (5 digits) dial setting (the factory default is 31).

Software address: It is realized by the "offset address" set by the configuration tool software (the factory default is 1).

For example:

If the hardware address is set to 5 and the software address is set to 113, the device address is 118.

【2DI + 2AI + 4DO】 MA02-AACX2240 User Manual

Figure 4-4-1 Device address

Table of Contents