Static Sign, Mounts, and Back Panel Removal ..................6 Static Sign, Mounts, and Back Panel Installation ..................9 Appendix A – LED Wiring ............................. 10 Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com carmanah.com...
NOTE suggests optimal conditions and provides additional information. Warranty Disclaimer This guide will familiarize you with the features and installation of Carmanah’s SPEEDCHECK-18 LED display assembly kit. Failure to comply with the use, storage, maintenance, installation or placement instructions detailed in this guide could void the warranty.
Page 4
Please contact Carmanah for additional information and guidance when adding or replacing beacons or other hardware. This guide is specific to the SPEEDCHECK-18 LED assembly kit installation and is not a replacement for the complete product user manual, Visit support.carmanah.com...
“88” + Slow Down Yellow Yellow Radar Speed The images in this guide may differ from your SPEEDCHECK-18 radar speed sign. They are for illustrative purposes only. Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com...
ENSURE DEVICE IS COMPLETELY POWERED OFF SO THERE IS NO DANGER OF ELECTRICAL SHOCK OR RISK OF DAMAGING EQUIPMENT. 1. Disconnect power from the SPEEDCHECK-18 sign by turning off the breaker or removing the fuse(s) in the associated power cabinet.
Page 7
Remove the six bottom screws on the front of the static sign. Lift off the static sign assembly and set aside to be reused with new display. Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com...
Page 8
SPEEDCHECK-18 LED DISPLAY ASSEMBLY REPLACEMENT GUIDE 7. Remove the sign mounts and top/bottom plates from the display and set aside to be reused with new display. Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com carmanah.com...
4. Mount the new system to the pole. 5. Reassemble back plate and wiring. 6. Reconnect power to the SPEEDCHECK-18 sign. Allow the system to power up and confirm all LED segments are functioning properly and the system is picking up traffic.
Left LED board = LED harness 3 only (7-pin) • Right LED board = LED harnesses 1, 2, & 4 (5-pin, 7-pin, and 3-pin respectively) Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com carmanah.com...