BaByliss 8437E - Mirror 7x/1x Magnification Manual

HOW TO USE

For more information about the advantages of this product, advice on the use and tips from experts, surf to our website: www.babyliss.com.
Please carefully read the instructions for use below before using the appliance.

PRODUCT FEATURES

1. Oval mirror with warm surround lighting: 16 X 22cm
2. 1 regular side and 1 side 7X magnifying
3. Rotating frame to tilt the mirror to the desired angle
4. Antiskid base
5. ON/OFF switch

INSTRUCTIONS FOR USE

• The mirror flips over, giving you the option of using either the normal flat mirror or the 7 times magnifying mirror.
• Plug in the appliance. Press the switch button to «I» to turn lighting on.
• After use, always switch off the appliance. Let the appliance cool down to room temperature before storing.

MAINTENANCE

If cleaning becomes necessary, unplug the electrical cord and wipe the outside of the appliance with a damp cloth. Clean the mirror with a glass cleaner. Do not switch the mirror on until it is completely dry.

BULB REPLACEMENT

Always turn switch to off position (0), allow to cool and unplug before replacing light bulbs.

This BaByliss mirror uses a 20W bulb. Do not use bulbs greater than 20W.

1. Unscrew and remove the screws from the sides of the mirror housing (fig. 1)
2. Place the frame as indicated and carefully lift off the top half of the housing.
3. Unscrew the old bulb and replace with the new bulb (fig. 2).
4. Carefully replace the top housing half after locating and aligning the screw holes to the bottom half. If the holes don't line up, turn top half of mirror 180°.
5. Insert the 2 screws into the holes and screw in.

SAFETY PRECAUTIONS

• 
  
  The polyethylene bags over the product or its packaging may be dangerous. Keep these bags out of the reach of babies and children.
  Never use them in cribs, children's beds, pushchairs or playpens. The thin film may cling to the nose and mouth and prevent breathing. A bag is not a toy.
  
• 
  
  Do not use over or near washbasins, bathtubs, showers or other containers with water. Store the unit in a dry place.
• If you are using the unit in a bathroom, unplug it after you have finished using it. Using the unit close to a source of water can, in fact, be dangerous, even if the unit is switched off. To ensure additional protection, have installed in your bathroom a residual current device (RCD) with a nominal trip current no higher than 30 mA. Ask your electrical fitter for advice.
• Never immerse the unit in water or any other liquid.
• Do not use the unit if it has fallen or if it appears to be damaged.
• Do not leave the unit unattended when it is plugged in or switched on.
• Unplug the unit immediately if you have problems when using it.
• Make sure the mirror is not positioned to reflect sunlight so as not to start a fire.
• Unplug the unit after each use and before cleaning it.
• Do not leave the unit plugged into the mains for longer than 24 hours.
• This unit is not intended for use by people (including children) with reduced physical, sensory or mental capabilities, or by persons who lack experience or knowledge, unless they are supervised or have been given instructions beforehand on the use of the unit by a person responsible for their safety. Children should be supervised to make sure they do not treat the unit like a toy.
• To prevent damage to the cord, do not wrap it around the unit and ensure it is stored without twisting or folding it.
• This unit complies with the standards recommended by Directives 04/108/EC (electromagnetic compatibility) and 06/95/EC (safety of domestic electrical equipment)

END-OF-LIFE ELECTRICAL AND ELECTRONIC EQUIPMENT

In everybody's interest and to participate actively in protecting the environment:

• Do not dispose of your products with your household waste.
• Use the return and collection systems available in your country. Some materials can in this way be recycled or recovered.