iRobot Roomba Combo j7 Owner's Manual page 11

Cleaning the Multi-Surface Brushes
1
Pinch the brush frame release tab, lift the
tab, and remove any obstructions.
3
Remove any hair or debris from the square
and hexagonal pegs on the opposite side
of the brushes.
2
Remove the brushes from the robot.
Remove the brush caps from the ends of
the brushes. Remove any hair or debris
that has collected beneath the caps.
Reinstall the brush caps.
4
Reinstall the brushes in the robot. Match
the shape of the brush pegs with the
shape of the brush icons in the cleaning
head module.
Cleaning the Front Caster Wheel
1
Pull firmly on the front wheel module to
remove it from the robot.
2
Pull firmly on the wheel to remove it from its
housing (see illustration below).
3
Remove any debris from inside the
wheel cavity.
4
Reinstall all parts when finished.
Make sure the wheel clicks back into place.
Axle
Housing
Important: A front wheel clogged with
hair and debris could result in damage to
your floor. If the wheel is not spinning freely
after you have cleaned it, please contact
Customer Care.
Roomba Combo j7 Owner's Guide
EN
Wheel
7