Yamaha R1 Owner's Manual page 26

Instrument and control functions
7-1 for starting instructions prior to
1
starting the engine.
Set this switch to " " to stop the engine
2
in case of an emergency, such as when
the vehicle overturns or when the throt-
tle cable is stuck.
3
4
The engine trouble and system warning
light and ABS warning light may come
5
on when the key is turned to "ON" and
the start switch is pushed, but this does
6
not indicate a malfunction.
7
Hazard switch " "
With the key in the "ON" or "
8
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
9
The hazard lights are used in case of
an emergency or to warn other drivers
10
when your vehicle is stopped where it
might be a traffic hazard.
11
NOTICE
Do not use the hazard lights for an
12
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
Mode switch "MODE"
Use the mode switch to change YRC
modes or edit the PWR, TCS, and SCS
EAU67360
settings from the main screen. This
switch has three buttons.
Up button - push this button to change
the selected YRC setting upward.
Center button - push this button to
scroll left to right among the MODE,
PWR, TCS, and SCS items.
Down button - push this button to
EAU66010
change the selected YRC setting
downward.
" posi-
TIP

The center button is also used to
activate the launch control system.
When the LCS icon is grey, push
and hold the center button. The
LCS icon will flash and turn white
when the system has been activat-
ECA10062
ed.

The traction control system can
only be turned off from the main
screen. Select TCS with the center
EAU66111


Wheel switch "
When the main screen is set to
STREET MODE, use the wheel switch
to scroll and reset the information dis-
play items.
When the main screen is set to TRACK
MODE, use the wheel switch to scroll
and reset the information display items
and to activate the lap timer.
When the display has been changed to
the MENU screen, use the wheel
switch to navigate the setting modules
and make setting changes.
Operate the wheel switch as follows.
Rotate up - rotate the wheel upward to
5-5
button, then push and hold the up
button until TCS OFF is displayed.
To turn the traction control system
back on, use the down button.
When TCS has been turned off,
the SCS, LCS, and LIF systems
are also turned off for all YRC
modes.
See "YRC Setting" on page 5-16
for more information on how to
customize YRC modes and adjust
YRC item setting levels.
"
EAU66100