Servicing Compute Unit Components; Servicing A Fdb Disk - Dell S5000 Series Customer Service Manual

Chapter 1. Servicing Compute Unit Components
1.1.

Servicing a FDB Disk

Important ATTENTION: Please read carefully the safety instructions
C009
C009:
Cabinet doors must remain locked at all times except during
maintenance operations.
Qualified personnel only are authorized to open the cabinet doors.
C004
C004:
Static electricity can damage the server and other electronic devices. To
avoid damage, keep static-sensitive devices in their static-protective
packages until you are ready to install them.
To reduce the possibility of damage from electrostatic discharge,
observe the following precautions:
Limit your movement. Movement can cause static electricity to build up
around you.
Wear an electrostatic-discharge wrist strap.
Handle the device carefully, holding it by its edges or its frame.
Do not touch solder joints, pins, or exposed circuitry.
Do not leave the device where others can handle and damage it.
While the device is still in its static-protective package, touch it to an
unpainted metal surface on the outside of the server for at least 2
seconds. This drains static electricity from the package and from your
body.
Remove the device from its package and install it directly into the
server without setting down the device. If it is necessary to set down
the device, put it back into its static-protective package. Do not place
the device on the server cover or on a metal surface.
Take additional care when you handle devices during cold weather.
Heating reduces indoor humidity and increases static electricity.
See
before you perform the procedures described in this
manual.
Multilingual Safety Notices Guide
CAUTION
CAUTION
Description Guide to locate the FDB disk
Chapter 1.

Servicing Compute Unit Components

1-1