1.4.1.
Removing a USB Raid SD Card (URS)
Required Tools
PH1 Cross-headed screwdriver
Procedure
1. Unpack the new component on a clean ESD-protected work surface
2. Open the cabinet front door
3. Open the cabinet rear door
4. Power off the partition
5. Disconnect all the cables from the server modules included in the partition
1. Check that all cables are correctly labelled.
2. Disconnect the cables to the power supply.
3. Disconnect the cables to the LAN.
6. Unplug all the PSUs
For each PSU, perform the following steps.
1. Pull the latch of the PSU up.
1-34
Customer Service Guide
Rear view